Login
Templates, Tools and Utilities
for Clarion Developers
Templates, Tools and Utilities
|
||
|
|
|
Icetips Article
Back to article list
Search Articles
Add Comment
Printer friendly
Direct link
Par2: Template modification to pass parameters - C4 1999-03-08 -- Arnor Baldvinsson The template change is easy. Open one file in the C4/template directory, ctlbrowa.tpw. First locate a
line starting with:
#CONTROL(BrowseUpdateButtons
In my template this is line 120. Next locate this line:
#PROMPT('&Update Procedure',PROCEDURE),%UpdateProcedure
this is line nr. 127 in my template. Add the following line right
below it:
#PROMPT('Parameters:',@s255),%UpdateProcedureParameters
Next locate this line:
%InstancePrefix:CallUpdate ROUTINE
This is nr. 500 in my template after adding the line above. Few lines
below you will find this code:
CLOSE(%ListView)
LOOP
GlobalRequest = LocalRequest
VCRRequest = VCRNone
%UpdateProcedure
LocalResponse = GlobalResponse
Change it to:
CLOSE(%ListView)
LOOP
GlobalRequest = LocalRequest
VCRRequest = VCRNone
#IF(%UpdateProcedureParameters)
%UpdateProcedure %UpdateProcedureParameters
#ELSE
%UpdateProcedure
#END
LocalResponse = GlobalResponse
This does it - you now have a parameter prompt on the update buttons
properties (action tab) where you specify the parameters in the normal
format:
(Loc:MyField, Loc:MyOtherField)
ie, with the surrounding paranthesis.
Today is April 27, 2024, 10:46 pm This article has been viewed 35108 times.
|
|